last nightI came back to the shop and filled in the screw holes with unfinished golf tees. I wanted to start from square 1 in the AM which I did.clamped front and rearI added a clamp in the middle holding the blade against the drawer guide. Screwed the front one first, nailed the back, and finally added a screw.doneI like this drawer guide assembly a lot. It is simple, easy to make and install. It is also hard to screw it up. And I don't have to allow for any expansion or contraction.test cutsDoing the tilt rails for the drawers. I made on cut on each end of the tilt rails centered on the width. However, the corresponding biscuit slot on the desk rails aren't centered. marking the slotI had marked the position of the slot off of the tilt rails. This block was for checking/setting the distance from the top edge for the slot. doneNailed the position just right IMO. The bottom of the tilt rails are exactly two frog hairs shy of being flush.doneA one inch #6 FH screw secures the ends of…
No comments yet. Log in to reply on the Fediverse. Comments will appear here.