doneI got three coats on the underside yesterday. First thing this AM I put a 4th coat on. It looked ok but I felt one more coat would give me a warm and fuzzy. first coatI used a cotton T shirt rag balled up. It went a lot easier than I thought it would. No drips or runs and no brush marks.drawer railGlued on the bottom drawer guide rail. Debated whether to just screw it on dry over gluing it. Another one of these will go on the back top rail and serve as support for the drawer guides.hmm......Testing to see if my reverse countersink will work. This scrap of cherry is the same width as the top drawer rail. First step was to drill a hole straight through top to bottom.lift offI replaced the tapered drill that came with the Fuller pilot screw/countersink. A #18 drill is the same size as the tapered drill bit. I first tried drilling it in forward but nada. I had to drill it with the drill in reverse as I pulled upwards. it workedIt is a little deeper than it should be but the important…
No comments yet. Log in to reply on the Fediverse. Comments will appear here.