53 minutes ago · Life · hide

smoothing the up faceIt took me about 10 minutes to get this thicknessed awfully close to the gauge lines. Used the #3 to smooth the face and flatten the scallops and plane tracks left over.hmm......I didn't go nutso on this trying to get the two faces parallel within +/- two atoms. The next step is to rout a chamfer on the front and two ends so getting it exact isn't necessary. Nothing will be married to it and the up face just has to be flat. A little texture can't hurt it neither, eh?side gauge lineI usually do good on getting down to the gauge on the sides. Although sometimes I end with them being just a wee bit high and wing like. Easy to correct for.opposite endThe ends give me the consistent headaches. The exit end, if I don't pay attention, will slope downward at the edge. The in fed edge tends to run high above the gauge line. It is something that I am aware of and pay attention to.sizing the lidI will be putting a gentle curve on the front edge. I want the outside ends of…

Commenting on Bubbles has been removed. Why? If you want to talk about this post, write to the author, use the comments on their blog if it has them, or reply with a "RE:" post on your own blog. Suggestions? feedback@bubbles.town