58 minutes ago · Life · hide

hmm.........Cleaned up the bottom of the upcoming lid. Planing a thin shaving was not a problem. Two runs R to L and L to R and it was done. No sucking oxygen and mildly short of breath.up faceI could go with either face of this being the up one but I like this the best. The right end has 'holes' that I don't know how it will behave. I have planed over similar ones and some tore out and some didn't. I don't know how attacking this with a cambered iron will react. I hooked up to the concentrator before I started with the scrub plane.1/4" to removePlaned a chamfer 360 just above the gauge line. At this end is the squirrely looking 'holes'. When I started planing the lower right corner it stayed high - it had hump that didn't want to get flattened.so far, so goodI was concerned that I might tear out chunks but I didn't. There was zero tear out planing diagonally R/L and L/R. Big sigh of relief on that stroke of good luck.minor annoyanceThe hose for the concentrator wasn't in the way and…

Commenting on Bubbles has been removed. Why? If you want to talk about this post, write to the author, use the comments on their blog if it has them, or reply with a "RE:" post on your own blog. Suggestions? feedback@bubbles.town