Part fit check

I spent a lot of time on the dry-fit stage of the French WC kit. There wasn't a rush, and I wanted to enjoy the build. More importantly, if significant work was required, the kit would need to go back in the box. Resin isn't lovely stuff to sand, the dust isn't good for you. Bad enough when it's just me, but we don't need to be exposing the public to anything. Luckily, there wasn't an issue. All the parts were moulded square and true. A bit of brushable superglue was all that I needed to hold the main walls together. The inside is a different matter. Once I'd figured out where everything went, it was a bit confusing; there were quite a few gaps that needed attention. Dealing with these was a mix of bits of Microstrip, and the filler I bought earlier in the day. The results aren't perfect, but they will do the job as you can't see much from outside. And here we have the model plonked together. Obviously, the roof and modesty screens aren't attached at this stage, these will go on after…

Commenting on Bubbles has been removed. Why? If you want to talk about this post, write to the author, use the comments on their blog if it has them, or reply with a "RE:" post on your own blog. Suggestions? feedback@bubbles.town