console/entry table pt XII..........

it has cookedReady to unclamp and see how things look. Spoiler alert - all the joint lines were tight and glue free. I hadn't forgotten to clean up glue squeeze out after I clamped it.Miller DowelsI think these are the 1X size and I'm using two at each end. My only choices were birch (these four) and cherry. As far as I know Miller doesn't have poplar dowels.nopeI used a half pattern to layout the end detail and it is off. The left side is over twice the size of the right. This would look like total crap if I did them. Time to execute plan 2.1D.hmm.......Shoulda, woulda, coulda, but didn't at the git go. I thought of this last night during my 3rd toilet trot race. I marked a center line end to end for positioning the pivot point of the beam. bottom shelfIt worked much better than the half pattern did. The bottom shelf extends past the outside edge of the aprons by less then 1/8" so I had to keep it tight.top shelfThe top overhangs the ends by 2" so I could make a larger chord here. I…

Commenting on Bubbles has been removed. Why? If you want to talk about this post, write to the author, use the comments on their blog if it has them, or reply with a "RE:" post on your own blog. Suggestions? feedback@bubbles.town