router planing sled pt II...........

doneNo tackiness on the tote or the tray. I'll bring this up to the living room and let the shellac fully cure out.router sled railsI couldn't double these up due to the 90° lip on it. These are stiff enough I think that it will be ok with one.rails doneI thought of moving this outside bearer to the outside edge of the back wall but I didn't want to drill any new holes in the rails. Four #12 screws hold each rail to the bearers.ready to try itI wanted the router to be 90° so the flats on the router base would butt against the upright walls of the rails but had to do it this way. The other way I would have had to cut the rails because they were almost touching in the middle. I didn't want to drill in the rails and I also didn't want to jigsaw a cutout for the router bit.hmm.....I checked the height of the bit and the two router sled bearers were too tall. I sawed 1 1/4" off both of them. With the router full down the bottom of the collet is about a 1/4" above the board. I will have…