DIY 6- to 8-inch Screw-Out Deck Plate Wrench 0 ▲ Sail Delmarva 68 days ago · Crafts · hide · Fediverse post In this case, there is no good commercial option. As common as these are, I have no idea why.My F-24 trimaran has 8 of these hatches on the outriggers (amas), and when sailed in spirited conditions, they go underwater a lot. The hulls pant a little with the water pressure, and unless snugged down, they leak a lot. It can be gallons per hour. Snugged down properly, they get stuck. Keep em' clean, keep em' lubed, they can still stick. Beckson makes a crappy wrench. People tap them with blocks of wood, use oversized Crescent wrenches, and even metal pin spanners, all of which can be damaging. The solution is a DIY wrench made with custom fitted stubs that fit the pockets, bolted or screwed to a wooden handle. A bad picture, but there will be a better article in Practical Sailor. Commenting on Bubbles has been removed. Why? If you want to talk about this post, write to the author, use the comments on their blog if it has them, or reply with a "RE:" post on your own blog. Suggestions? feedback@bubbles.town