Halberstadt D-II 0 ▲ Shouting Into The Void 80 days ago · Tech · hide · Fediverse post I printed some 1/144 scale Halberstadt D-II fighters yesterday, and they turned out not to be without issues. Issues which I didn't notice, alas, until it came time to remove the supports to reveal the printed model underneath.Each of them printed with a semi-broken back, probably because the models were printed tail-down at about 60° to the build plate, and lacked any supports along the underside of the fuselage, so they sagged just a little bit before the upper layers started printing.I've rebuilt the gcode with more supports in the problem area and I'm trying another one; we shall see how that turns out. They also all printed the tail fin poorly. I added more supports there too, but that problem isn't nearly as troublesome to me. They're all usable as gaming models, even as they are, but I would prefer it by far if they were less flawed. Commenting on Bubbles has been removed. Why? If you want to talk about this post, write to the author, use the comments on their blog if it has them, or reply with a "RE:" post on your own blog. Suggestions? feedback@bubbles.town