first bookcase pt III.........

I didn't forgetMade a test rabbet to ensure the fit was ok. This is the plywood I intend to use. Lowes sells 1/2 sheets (48 x48) but it is something that I don't see that often in stock. If not I'll buy a full sheet and have it sawn in half.doneAdjusting the plunge router is/was a ROYAL PITA. It was stiff, uncooperative, and damn near impossible to nudge up/down a frog hair. It took me a bazillion years to get it to the depth I needed. I left it set on it so I can rout the top and bottom rabbets later.oopsHad a senior moment and made the notch wrong. It would have been dead nuts if the shelf went in on the long edge. Way out in left field with the shelf in its correct position. Since I'm painting this I will save the off cut, glue it in instead of making a new shelf.fitted itThe plan is to put the shelves in after the top is glued and set. I don't want the shelves binding and stalling when I do that. I made the shelves a wee looser by planing a few fuzzy shavings off of each side at…