Brushless Motor Model

The future of motors is brushless. Lets's start teaching them. Materials 5/16 inch carriage bolt or other full thread bolt about 3 inches long 6 5/16-inch nuts 3/4 inch square of wood or plywood approximately 4 inches x 4 inches 5/16 inch drill bit 1 inch Forestner bit (or alternatively rubber feet) Hammer Plastic bobbin like this Enamelled magnet wire (something around 28 to 30 gauge is fine) like this Bobbin winder from a sewing machine or a standalone bobbin winder like this Electrical tape 7/32 inch (approximately) drill bit Small piece of wood or plastic approximately 1/2 inch by 1 1/2 inch with two holes 1 inch apart, center to center. One hole is 5/16 inch diameter and the other hole is 7/32 inch. 1 inch panhead #12 (or around 7/32 inch in diameter or smaller) screw (preferably plastic, brass, or non-magnet stainless steel). Matching (same size as above) nut Matching screwdriver (flat head or Phillips as above) Fine sandpaper Fidget spinner (full size) like this Flat head…