little side project........

hmm.......This is the little side project. I am going to make a new holder for the new Vix bits I just bought and for the drivers too. doneStill haven't found the pics for the big frame on the right. I'm on the fence about the small certificate frame. The router wobbled while routing the profile and it left a few dips, hollows, and one divot on the top rabbeted edge. They aren't noticeable looking at the frame from a foot away but they are visible up close and personal. I am letting it be for now and if it continues to gnaw at me I'll make another one later on down the line. I am rusty routing profiles with a corded router and I don't have a router table that would have eliminated the headaches with this frame. hmm......The hex drive on these bits are a frog hair over a 1/4". A 7mm drill bit leaves enough wiggle room to get the bits in/out of the holes.huh???There are doubles of these two Vix bits. Why? I looked at the pic and write up in Amazon and it has the doubles there for all to…