two more frames.......

fixing a missed stepI didn't plane a reference edge before I ripped the cherry frame to width. All four of them were uneven - they had humps that didn't line up. Went back to square one and planed one edge flat, straight, and square to the reference face. Still making me-steaks that bite me on the arse.sighThis was the 4th attempt to make the frame for the Declaration. I kept missing getting the length of the sides correct. I kept screwing up the inside and outside lengths. This frame is ok - ish but not correct. The mat would be less than 1" all the way around and I want it to be a minimum of 1 1/2".I got the reference edge and ripped all the parts to the same width. I like the look of a thinner frame. One miter was off when I checked it with Mr Starrett. I had to redone both of the two short sides to fix the errant miter. last oneMade a command decision and put the current frame aside and ripped out 4 new frame parts (with reference edges). I did two miters on the left and the other…