hardware dresser pt XIV........

dry fitted dividersI applied glue to the underside only. I didn't put any glue on the vertical ends.hmm......The dividers were a frog hair off but there is enough flexibility in 1/8" plywood to align them with the grooves. Decided to fit each drawer I've done so far rather than wait until all five are glued and cooked.layout for the half lapsWith the nine compartment layout I only have to layout for one end. I set the distance for it, sawed it, and then flipped it 180 to saw the other end.fittingFirst step was to flush the 1/8" plywood all the way around. It is getting easier to fit drawers. The key for me is one, take my time. And two, look at the fit of the drawer from the front and the rear. Thirdly, don't go nutso and take too many shavings at once. one down, four to goI am not that thrilled with the look of the plywood bottom. I glued it to the bottom because I didn't want the bottom inset in grooves. I also didn't want to give the little bit of real estate that would have eaten…