hardware dresser pt XII.....

I was wrongI had more than enough pine to get all the drawer parts. Four drawers all the same size and one drawer about 1/4" smaller. Also got lucky that depth and width of the drawers were less then 12".extrasThese are for any oops. I don't know how I missed thinking I didn't have enough stock to get all the drawer parts.hmm.......Got one edge flat, straight, and square. I used that to square the ends and get the length.snugThe R/L is loose - it is about 2-3 frog hairs short. It is good enough for a parts dresser. first drawerI will use through dovetails at all the drawers. I thought of using half blinds but nixed it. A single dovetail is enough for drawers of this size. for the dividersEach drawer will have 9 compartments. I could have added more but I wanted to ensure that each plastic hardware container would fit in each compartment. Instead of using 1/4" thick poplar for the dividers I'm using 1/8" plywood.yikesThis side split when I glued the drawer up. I glued and clamped it…