miter sled jig pt II.........

last nite after dinnerThis had been in the clamps for almost 5 hours and I was anxious to see how it looked. I did some after dinner puttering in the shop.Mr Starrett says all is goodThe outside was good - not dead nuts. There was about 1/2 a frog hair of light on the left end. The inside was dead nuts 90Happy with how this came out. The top face is flush along the joint line but the other face isn't. That is because the two pieces aren't exactly the same thickness. In spite of that the toes and heels are aligned which is the important thing.hmm.......Decided to glue the cap on the back rail before heading topside. I clipped the ends at a 22.5° angle. glued and cookingIn the AM I can get this attached to the sled and road test it with making a frame.start of the AM sessionFlushed the test miter, top and bottom to get a better look of the joint line. Toes and heels were tight and the joint line was tight and gap free. I couldn't break the miter neither. I whacked it on the bench and…