hardware dresser pt XI.........

one down, 3 to goThis was a wee bit difficult to get the notch measurement in the cross rail. Once I figured that out I whacked them out one at time.go/no/go stickThe rails were all about 1/8" over length and the stick was a slip fit between the dadoes R/L. In hindsight I should have did the go/no/go stick before I sawed the notches at the top for the rail ends.last oneI sawed out all the rails with the dozuki saw. No problems except with the 3rd one. The distance between the dadoes was a few frog hairs less then the others. I trimmed the notches equally with a chisel until it fit.I was pleasantly surprised by how well I sawed the notches. I didn't wander into La La Land with any of them. All the vertical saw cuts split the pencil almost dead nuts. I had thought of doing the cuts on the tablesaw but nixed it. No blue chips for taking the easy road. These were the best (multiple) precision saw cuts I've done.dry fitHappy with the fit. The front is within a frog hair of being flush and…