hmm.......I'm trying to reverse engineer how I made this frame and I ain't doing so good. Don't remember how I did the beading on the inside edge. The outside edge I used a router bit and I dimly recall using a hand plane to do the bead. The miters look good and there isn't any chips or blowout on any of the bead heels. The initial plan is make the 2nd frame look like this one.howIt kind of looks like I half lapped the corners but it looks too small. There also isn't any evidence of that other then this corner. I can't see a spline either and I don't think I would do a miter without one - I don't like miters and I wouldn't depend on just glue to hold one together. I have plenty of time before I get to the mitering stage to figure it out.didn't see thisI ripped the rough sawn left edge before I ripped out the frame pieces. Wasn't expecting this tapered cut off to pop up. working the dresser moldingI only need three pieces for the plywood back on the dresser. I will nail the bottom of…
No comments yet. Log in to reply on the Fediverse. Comments will appear here.