chamfering the holesThis doo da does an acceptable job chamfering the dowel holes.problemI initially knocked down the top of the holes with a chisel but I could still feel a wee bit of a raised bump. The hand chamfering tool got rid of that. I didn't want anything to keep the rail from laying up tight to the legs. It also gives a little relief for glue.sighI need to chamfer for the head of the screw I intend to put here. I have off set screwdrivers for driving the screw but no offset chamfer doo da. I have an idea percolating in the brain bucket. It is a trick I saw on a Popular Woodworking You Tube post. Fingers crossed that it will work.back railsI had to take the back rail slats out again to plane/clean up the top edge with the mortises.two tapsDoing the last dry clamp before gluing it up. I put a piece of blue tape on the leg face that the side rails will be glued to. hmm.......The offset that I knew about shook hands with me. Rather than glue a piece on the top I am leaving this…
No comments yet. Log in to reply on the Fediverse. Comments will appear here.