1/8" router bitIt is solid carbide with a 3/4" long cutting length. I like how easy it was to make the slots for the table clips with my plunge router. Hopefully I'll remember to do it before I glue the rails up.hmm......Missed about one inch on the first pour. In my defense it was covered with tape. Filled it in and all the other sunken holes.not expectedIf I had known I would have stuffed in cherry shavings before filling them with epoxy. Fingers crossed that the 2nd pour will fill them. done30 minutes after I filled them, all the holes were over filled. Looking like a win for the home team.gluing the topThe middle and right board are carved in stone. The far left board is one of two that I will marry to them.still workingI worked through all the ways I could use these two left boards and it took a while to make up my mind. There is no way I could get a color/grain match with the other two. I started by sawing about an inch off of the two right boards. I did that so that the third…
No comments yet. Log in to reply on the Fediverse. Comments will appear here.