a good sighFirst of the make up mortises on the correct side of the rail. I think it is now impossible for me to screw this up again.hmm.....Got the banding at the top done all the way around. When I did a sneak peek preview, the bandings were not visible with the top on. There is a one inch overhang of the top past the outside edges of the legs.bottom shelfThe new bland bottom shelf. I had thought of sizing the bottom shelf so that it extended to outside faces of the legs. Switched lanes and decided on this - the shelf in between the inside edges of the legs. However, I think I made it too tight R/L. I don't have to worry about expansion/contraction this way but I didn't like how tight it was.hmm......I think this will look more balanced if there is a slight gap on the ends.another lookI don't think this looks out of place. The important point is that my me-steak table top clips are covered and hidden. When I chopped the mortises on the correct face I ended up with through mortises.…
No comments yet. Log in to reply on the Fediverse. Comments will appear here.