I went to Koszela Lumber today and got the cherry for the upcoming small table. I finalized the plans for it in my head but that doesn't mean that is what I'll make. I'm still a little fuzzy about how to attach the legs and the number of aprons are still subject to change. Hope to start on that in the AM or monday at the latest.4/4 cherryI was hoping for rough sawn but she didn't have any. This 4/4 is dead on 3/4" thick. Two, five foot boards 3 1/2" wide for at least 4 aprons. Three six boards 9 1/4" because they looked too good to leave there. Two of the boards have a bunch of pin hole knots that look like birds eye maple. One of those will be for the bottom shelf.sighI think I finally have solved this plane. The right side flat seat is lower than the one on the right. This is the best I could come up with to measure it. Would be better if I had some machinists measuring tools to do it properly.hmm.....This is a new iron from Lie Nielson for my 9 1/2 blockplane. There is a flat at…
No comments yet. Log in to reply on the Fediverse. Comments will appear here.